MARLIN FLEXY ANTIFOULER FOR INFLATABLE BOATS 0.5L



€33.50

Inflatable boat antifouling

COLORE
Qty

MARLIN FLEXY ANTIFOULING FOR INFLATABLE BOATS

Flexible antifouling for inflatable boats, can be applied both on tubulars and on fiberglass keel. It must be applied directly, without primer.

FLEXY is a water insoluble antifouling, therefore it is also suitable for very fast dinghies.



USE

1.Wash and degrease the surface thoroughly, completely removing grease or wax stains.

2.Slightly sand the surface, using: on fiberglass abrasive paper no. 100-120; on vinyl leather and inflatable paper finer paper, n. 180-200, or abrasive felt (Scotch Brite type) to avoid possible damage to the fabric itself.

3.Do not apply any primer on the tubulars or on the gelcoat of the rigid keel

. If a cycle based on epoxy products has been applied to the fiberglass, sand with 100-120 paper, apply a coat of FIBERGLASS PRIMER and wait at least 3 hours before applying the FLEXY antifouling.

4. Then apply two coats of FLEXY antifouling on the prepared surface at least 6 hours apart.

5. Wait for the launch at least 16 hours (at 20 ° C) from the last coat.

WARNINGS

Mix very carefully before use.

Do not apply on light alloy boats.

Do not apply on other types of antifouling.

Do not use with temperatures below 0 ° C or above 38 ° C. In cold temperatures it is important

wait at least 48 hours for launching after the last coat.

Apply at least 2 coats with a minimum consumption per coat of 9 m2 / l

If the boat remains moored for long periods, any silt or dirt formed must not be removed with abrasive products (not even abrasive felt), but with a sponge or cloth.

2045847
10 Items

Specific References

Review

Write your review

MARLIN FLEXY ANTIFOULER FOR INFLATABLE BOATS 0.5L

Inflatable boat antifouling

Write your review

Related Product